Hose Whip Check Nylon 2-ply 3640 bar

Product description

Hose Whip Checks

Helps to protect workers from injury and your equipment from damage.

To reduce damage to equipment and injury to personnel when hoses accidentally disconnect while under pressure, be sure to use the new One Ply nylon whip check.

Suitable for use on pneumatic, water (high pressure) vacuüm - and hydraulic hoses, these easy to install straps are made from strong, flexible nylon webbing. Slide the rubber grommets (2x) to keep choked eyes snug on the hose.

The available standard length of 75 cm. (30”) will accommodate hoses with inside diameters from 1/4˝ up to 2˝.

A "whip check" can be attached at any point where two hoses are joined, or to a pumps fluid end at the discharge side, or where a hose attaches to any piece of water jetting equipment such as a water jet lancing or cutting system.
When a high pressure hose is joined to a piece of equipment, the whip check should be used to restrain the movement of the pressurized hose should it become uncoupled, thereby allowing operators to get away and perform a safe, orderly system shut-down.

This Two Ply version gives two times extra strength and up to ¼" hose safety of 3.640 bar (52.000 psi).

Picture shows high-strength brightly- colored nylon with rubber cinch bands.
Different lengths available.
Please note this version is with 2 rubber stops and there is no danger this will stick to different objects when you move the hoses. There are other simulair whip checks on the market with aluminum / steel clamps who will stick to objects who are not safe, beware of this.

Length ± 50 cm. (20") P/N : 143-010-012
Length ± 60 cm. (24") P/N : 143-010-013
Length ± 75 cm. (30") P/N : 143-010-002 (most standard)
Length ± 1,1 mtr. (44") P/N : 143-010-004
Length ± 1,6 mtr.(64") P/N : 143-010-003 (special use for vacuümhose 3"and higher, see pictures with the blue 4"hose)